Wholesale Dealer

Tutorial Video

Instructions: Dragan Pod

Although the Dragan Pod setup is straightforward, here are the steps to help you get started!

  1. Unpack the Pod components and remove the retaining clips.
    Unpacked Dragan Pod kit showing disassembled pole segments, hardware, and protective carry case laid out on a table.
  2. Assemble the tube segments to the desired height. Note: The recommended load reduces with length (1-Segment: 1000 lbs, 2-Segments: 750 lbs, 3-Segments: 500 lbs).
    Connected Dragan Pod carbon fiber tube segments assembled horizontally with modular joints.
  3. Insert the foot into the bottom tube.
    Close-up of the articulated rubber foot attached to the base connector of the Dragan Pod segment.
  4. Insert the tube retaining clips
    Orange retaining clip installed securely over the Dragan Pod tube joint connection
  5. Insert the crown on the top segment.
    Blue CNC-machined crown component mounted to the top segment of the Dragan Pod.
  6. Ensure the top pulley is in the forward position (the middle position will be used for upcoming Pocket Winch accessories).
    Detail view of the Dragan Pod top crown showing pulley wheel placement in the forward position.
  7. Attach the Pocket Winch to the crown.

  8. Unscrew the red line-retaining screws, place the line across the top of the pulley wheels, then resecure the screws.
    Dragan Pocket Winch mounted to the Pod crown with synthetic line routed past the red line-retaining screws.
  9. Unspool the line from the Pocket Winch until there are three wraps remaining on the spool.

  10. Use the Capio to attach the load and use the guy shackles to stabilize the Pod as necessary. Note: It is normal and OK if the pulley wheel(s) do not rotate during use, depending on the load and conditions.
    Outdoor demonstration of the Dragan Pod and Pocket Winch fully rigged with synthetic lines and stabilizing guy shackles.

Key Takeaways for Safe Operation:

  • Respect Load Limits: The Dragan Pod's capacity changes based on height. Never exceed 1,000 lbs for a 1-segment setup, 750 lbs for 2 segments, or 500 lbs for a fully extended 3-segment setup.
  • Maintain Spool Wraps: When unspooling your line for a recovery, always ensure a minimum of three wraps remain on the Pocket Winch spool.
  • Prep for the Backcountry: Since you'll likely be out of cell service during a recovery, we highly recommend downloading the Lower Resolution (470 MB) tutorial video directly to your phone before your trip.